Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.

New: Take Part in the May's Giveaway: Win the LIVALL PikaBoost 2 E-bike Conversion Kit


Loosening bolt in non-drive side
#1
Hello boardmembers,

I recently upgraded my bottom bracket and crank set.
The bottom bracket is sealed and I was told that this bottom bracket and crank set were made with JIS standards.

Anyway, the my older bottom bracket used a nut to hold the crank in place while this new bottom bracket uses a hex bolt to hold the new crank in place. The thing is, on the non drive side, I have to turn the bolt clockwise to tighten, likewise for the drive side.

As I ride my bike, mostly while standing to give more force, the non-drive side bolt loosens because as everyone knows, the non-drive side turns counter clockwise.

Therefore, the bolt loosens. I was thinking maybe I should take a rubber mallet and hit the crank inward more to then tighten the bolt but I came to ask if my bottom bracket was broken. Is it?

I appreciate your help.
  Reply
#2
If it is new and properly torqued it should not come loose. makes no difference if you have a nutted spindle or a bolted spindle. If your crank is rotating enough to loosen the bolt/nut it could be damaged or not seated properly.
I understand what you are saying about the non- drive side and rotation, but with your crank arm it does not matter. yours just happens to be on that side. When torqued properly you are pressing the crank onto a spline and need a puller to remove it.
There are two kinds of people in the world, "Those who help themselves to people, and those who help people!"
  Reply
#3
Thanks
I also read elsewhere that this could be due to being goofy footed, leading with the right foot.
I'll test it out as well as make sure the crank arm is on right.

Thanks again
  Reply
#4
As pk noted; if the crank arms are properly installed, the bolt (or nut) does almost nothing.....and even if you removed it, you could not pull the crank arm off without a tool.
Nigel
  Reply
#5
The left crank arms tends to loosen easier than the right because the chain on the drive side absorbs a lot of the pedaling force. On the left, all the force goes thru the crank/spindle junction to get to the other side. So it is under higher loads. That said, as above, a properly seated and tightened crank arm should not loosen. Using a hammer will just damage the bearings. Use a torque wrench.
  Reply


Possibly Related Threads...

Forum Jump:

[-]
10 Latest Posts
What was your first bicycle?
Today 10:43 PM
First long distance ride..
Today 10:33 PM
Is anyone riding with music?
Today 10:12 PM
Great Giro
Today 09:57 PM
Rusty chain inspite of cleaning,lubing
Today 09:54 PM
What are your best tips for long rides?
Today 06:26 PM
Massive Chainring redux
Yesterday 06:47 PM
POLL: Are non-recumbent riders looking a...
Yesterday 05:26 PM
Third best reason to ride a bent or trik...
Yesterday 04:51 PM
The great thing about trikes
Yesterday 04:33 PM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. Criminal
18 posts
no avatar 2. GirishH
17 posts
no avatar 3. Painkiller
16 posts
no avatar 4. Flowrider
15 posts
no avatar 5. SPINMAN
14 posts