Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.


Bike care after a rainy ride
#1
Ciao.
Me and my Giordano both got soaked during a training ride, within the last two miles haha. Funny but it's the first for me. So I'm asking you guys if there are any precautionary methods to ensure that my road bike doesn't take any damage in long term? There is road dust on the frame and on derailleurs. Should I give him a quick rinse (or use a spray? is it a thing?) or clean it more thoroughly?

Thanks!
  Reply
#2
you can spray it down anytime to keep it clean, do not use soap around any bearings..i.e.. headset,BB, rear cluster, brake pivots , wipe or blow dry. and just keep her lubed. Thats all you really need to do to maintain.
There are two kinds of people in the world, "Those who help themselves to people, and those who help people!"
  Reply
#3
(07-28-2020, 08:24 AM)ManBearPig Wrote:  Ciao.
Me and my Giordano both got soaked during a training ride, within the last two miles haha. Funny but it's the first for me. So I'm asking you guys if there are any precautionary methods to ensure that my road bike doesn't take any damage in long term? There is road dust on the frame and on derailleurs. Should I give him a quick rinse (or use a spray? is it a thing?) or clean it more thoroughly?

Thanks!
If you keep your chain well lubricated, you can "rinse" it with low pressure water to help remove grit and fine debris. The chain is wet anyways so your are not causing any more damage than what has potentially been caused by running it in wet conditions. Towel off excess moisture from it and blow/fan dry the chain before relubing. Avoid getting water into pedal, hub, pulley, and/or crank bearings if you are performing this work with the chain still installed. You can do the same thing with a "dryer" (lightly or no lube) chain, but you must dry the chain as quickly as possible (spraying with alcohol helps) to avoid any rust damage, and of course, thoroughly lube the chain once dry and before use.
  Reply
#4
That's what I needed, I appreciate your advice @Jesper @Painkiller. What about using a hose and higher pressure water? Does it make a difference?

Thanks!
  Reply
#5
(07-30-2020, 06:42 PM)ManBearPig Wrote:  That's what I needed, I appreciate your advice @Jesper @Painkiller. What about using a hose and higher pressure water? Does it make a difference?

Thanks!

no problem with high pressure just keep it away from the bearing areas as with soap. be careful with high pressure on antique bicycles and fragile decals and such. But nothing wrong with a rag and a bucket with a good rinse and dry either. My method of choice. The only time I would resort to spraying off my bike would be if was totally caked in mud.
There are two kinds of people in the world, "Those who help themselves to people, and those who help people!"
  Reply
#6
(07-30-2020, 06:42 PM)ManBearPig Wrote:  What about using a hose and higher pressure water? Does it make a difference?
Thanks!
I agree with Painkiller. I will spray off a bike at higher pressure when it is a muddy mess, but l have removed the wheels and wrapped the bottom bracket and derailleurs in plastic. Also, I tend to rebuild after a really dirty ride; though not for just a rain shower. Since I ride older bikes, most of my bearings are not sealed "cartridge" type, so high pressure spray is not the best method. I think newer bikes can withstand more exposure to moisture in that they are better sealed. Still, make sure the bike gets dried immediately after you wash it. Blow drying is best and quickest; if leaving in the sun, flip it over occasionally.
  Reply


Possibly Related Threads...
Thread
Author
Replies
Views
Last Post
 
2,328
06-08-2022, 06:58 AM
Last Post: Jon Aston
 
2,251
12-11-2020, 08:17 PM
Last Post: Terry Poage
 
10,266
05-26-2020, 04:54 AM
Last Post: Joe_W

Forum Jump:

[-]
10 Latest Posts
Post-Ride Nutrition
Today 02:06 AM
🚴‍♂️ Saddle Up for the Belgian Waffle Ri...
Today 02:03 AM
Pre Ride Food Intake
Today 12:14 AM
SAVA Explorer 6061?
Yesterday 03:31 PM
braking by reversing the pedals
Yesterday 01:00 PM
Zwift v Spin v Wahoo
04-01-2025 05:59 PM
Have you Ever Tried an Electric Bike?
04-01-2025 05:07 PM
Good Morning from SW Ohio
04-01-2025 07:32 AM
(So California) PV Dr to be closed to bi...
03-31-2025 09:14 PM
Tubeless vs. tubes: What are the pros an...
03-31-2025 08:28 AM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. GirishH
22 posts
no avatar 2. Flowrider
19 posts
no avatar 3. meamoantonio
12 posts
no avatar 4. Jake1
11 posts
no avatar 5. enkei
9 posts