Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.


Creative bike mechanics (freehub) [Solved]
#1
Just wow, this calls for the bicycle repair photo of the month prize! Big Grin
As this bike rider himself explained, his friend's freehub turned fixie during the ride, and they used such creative tool to get the 16mm nut out of the hub.

   
  Reply
#2
Mercy, ha
There are two kinds of people in the world, "Those who help themselves to people, and those who help people!"
  Reply
#3
(08-04-2019, 07:39 AM)Zviedrs Wrote:  Just wow, this calls for the bicycle repair photo of the month prize! Big Grin
As this bike rider himself explained, his friend's freehub turned fixie during the ride, and they used such creative tool to get the 16mm nut out of the hub.
I recently replaced the freehub on my Specialized Fatboy. It required a 12mm hex wrench, and hardware stores don't sell anything bigger than 10mm, so I had to order it, online.

Trying to turn the wrench with a piece of pipe, didn't work. Probably needed a longer pipe but I was afraid of doing damage to something. So I put the wrench in a vise and lowered the wheel onto it. Had to jerk it counterclockwise a few times until it snapped free. I don't know why they tighten the nut so much. When I put it back I tightened it but not so hard that it was almost impossible to undo. After tightening it, I was able to loosen it again, with the aid of the short piece of pipe. Ridden it another 1,000 miles since then, and no problems.

My freehub hadn't turned fixie but while wheeling the bike out, one morning, I became aware that the pedals were turning. I expect that when pushing the bike backward, but not when pushing it forward. I had to think about it because I never noticed the pedals turning, before, and I ride it every morning.

I removed the freehub and it seemed fine. Screwing it back onto the hub, and it was a little stiff if I tightened the lock ring properly. By loosening the lock ring so that it was barely holding, the freehub turned freely. Apparently over 5,000 miles had put a bit of wear on it. Got the new freehub, tightened it properly, and the pedals no longer turn while pushing the bike forward.

I'm thinking I might have suffered a fixie, too, before long.
If I knew how to ride a bike properly, I'd do it every time.
  Reply


Possibly Related Threads...

Forum Jump:

[-]
10 Latest Posts
New to the Forum - Introduction
Yesterday 05:38 PM
Would you like a pizza after cycling?
Yesterday 02:10 AM
Hardtail as only bike?
07-12-2026 05:23 PM
Spoke Count Preference
07-12-2026 09:17 AM
Pros & Cons of presta valve vs schrader ...
07-12-2026 03:34 AM
Are you mainly into Mountain Biking, Roa...
07-12-2026 02:20 AM
New around here
07-11-2026 10:53 AM
Favorite MTB brand?
07-10-2026 03:16 AM
29"front & 26" rear? Thoughts?
07-10-2026 03:13 AM
suspicious broken part after service--is...
07-09-2026 02:45 PM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. Flowrider
27 posts
no avatar 2. meamoantonio
17 posts
no avatar 3. GirishH
17 posts
no avatar 4. ReapThaWhirlwind
15 posts
no avatar 5. Mr. Beanz
13 posts