Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.


Beware Park Tool CCP-44 Incompatible with Shimano Octalink
#1
Purchased this last week and went to pull the crank off today. What I found is that the threaded hollow on the non-drive side is too shallow to fit both the bullet and the threaded extractor nut. With the improvisation, I was still able to remove the non-drive by using a small, thick washer. Certainly not recommended though. I believe I saw Shimano makes their own crank puller for Octalink, so that may have to do with the profile. It was to sell their own tool.

Just want everyone to be aware so you don't find yourself in this same situation.


Attached Files Image(s)
       
  Reply
#2
Thanks for the tip/warning
  Reply


Possibly Related Threads...

Forum Jump:

[-]
10 Latest Posts
What are the pros and cons of clip-on pe...
Yesterday 03:06 AM
What must-know bike care tips are we ove...
03-10-2025 08:51 PM
Cycling industry is pricing out their ow...
03-10-2025 07:59 PM
Where are you from and What is your favo...
03-10-2025 07:48 PM
The Best Bike Chain Lubes for Mountain B...
03-10-2025 06:58 PM
Would an Advanced Society Benefit from B...
03-10-2025 01:15 PM
Snow belt cyclist
03-10-2025 12:58 PM
Best suspension seat post?
03-10-2025 10:11 AM
Greetings from W.N.Y.
03-09-2025 11:27 AM
Removing and refitting rear wheel on bel...
03-09-2025 03:21 AM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. GirishH
21 posts
no avatar 2. Flowrider
14 posts
no avatar 3. meamoantonio
14 posts
no avatar 4. rydabent
12 posts
no avatar 5. enkei
11 posts