Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.

Best Black Friday E-Bike Deals 2024 | Up to $1,700 in Savings

New: Take Part in the November Giveaway: Starts November 18th


Replace grease with oil?
#1
As an inline speedskater, I cleaned my bearings weekly since I replaced the grease with high speed oil. It may have been a bother but the difference in speed made it a no brainer. Does anyone do this? Any special tools required to make sure bearings are aligned? I've read an article on this site about overhauling hubs and repacking the grease but is it too major of a job in bike hubs to do once a month. I don't expect to have to clean them weekly since the hubs are much farther off the ground and away from the dirt than speedskates. Any speedskaters out there who can relate?
  Reply
#2
No personal experience...but supposedly some track bike racers use oil instead of grease. I assume it would give you some improvement. However, the downsides are obviously that you need to repack the wheel often. With a couple hand tools and practice, this shouldn't take any more time than your skate bearings. However, I would say that the risk of damaging the bearing races is higher in that if you mess them up, it can mean buying a whole new hub instead of just a new bearing. Most bikes have one bearing surface built into the hub itself. Also the issue of the oil leaking out and getting everywhere (on braking surfaces?).

The benefits may be questionable. A bike wheel turns at much lower rpms than a skate wheel so grease doesn't create as much drag here. Probably the two biggest factors in bike speed (beyond the rider) are aerodynamics and rolling resistance of the tires. Tires are probably the most overlooked aspect and different makes can have very different levels of resistance and higher price is no easy guarantee of a faster tire.

I'd say spend the 1-2 hours/week you'd spend re-oiling your wheels either riding or earning money to buy better tires. Probably have a bigger impact on your speed.
  Reply
#3
Good point about the rpm's...i didn't. onsider that. btw, what are some fast wheels if you wouldn't mind providing me a short cut? Smile
  Reply
#4
Tyres: depends what is "fast" for you. If you get a flat on the bike leg of a triathlon you'll lose more time than if you had used the slightly slower but more durable tyres. I like Conti GP 4000s (they are now replaced by the Attack / Force combo), they are sturdy and fast rolling (several tests showed this). Schwalbe is preparing a new tyre for 2013 that is supposedly as fast and maybe better. Additionally, tubeless technology is improving for road bikes, might be a good thing to check out. For tyres, also read:
http://www.slowtwitch.com/Tech/All_About_Tubeless_j2799.html
http://www.slowtwitch.com/Products/Things_that_Roll/Tires/Fast_Tires_for_2012_-_2_j2686.html

Fast wheels: Zipp Firecrest 404 or 303 in the front and maybe a disk in the rear... but this can really depend on the frame! There was a test in Tour-Magazin (German cycling rag) two or three months ago, where they had that effect: another wheelset was much better in one frame than the Zipps.

Oh, and most of the high-end bearings cannot be repacked since they are "sealed" bearings, that is not cup and cone but rather a cartridge (note that sealed does not mean they are more waterproof than cup and cone bearings)
I recently found this article
http://www.slowtwitch.com/Tech/Bearing_Breakdown_2822.html
could be interesting for you, too

For non-racing I would use something like:
- high-end Shimano cup-and-cone hubs (serviceable)
- Halo Mercury rim (reasonably fast + light + no carbon)
- DT double butted spokes (or maybe "aero" spokes), stainless steel
- laced cross three (reliable pattern), maybe radial in the front (not too much lateral load, not-measurably-decreased drag, almost no weight reduction.... but looks better?)
Now I need to go and find them... and tell my wife I bought bike stuff again.
And it is your fault ;-)
  Reply


Possibly Related Threads...
Thread
Author
Replies
Views
Last Post
 
700
10-22-2024, 09:38 AM
Last Post: rydabent
 
29,362
10-10-2012, 05:50 PM
Last Post: SPANNER
 
Guest
105,869
02-06-2012, 01:41 PM
Last Post: nfmisso
 
84,837
12-22-2011, 02:10 PM
Last Post: Joe_W
 
31,490
08-03-2011, 07:20 PM
Last Post: nfmisso
 
19,702
07-04-2011, 10:30 PM
Last Post: gcb
 
42,345
06-22-2011, 03:47 AM
Last Post: Dalton2250
 
31,278
04-30-2011, 09:15 AM
Last Post: KC-Steve

Forum Jump:

[-]
10 Latest Posts
Second wheelset for ebike.
Today 01:41 AM
Moving in Style: Beyond Regular Transpor...
Yesterday 09:23 PM
Tire Sizing (Or How to Buy A Tire)
Yesterday 12:36 PM
The Roaming Radrunner Vlog 1 Why ride ...
Yesterday 09:17 AM
Recording Bike Rides
11-20-2024 01:37 AM
Ketone Ester $$$
11-19-2024 01:04 AM
Trek domane tyre
11-18-2024 01:58 PM
Old fossil buys Ebike
11-17-2024 06:39 AM
Bike bus
11-17-2024 12:14 AM
Humber "Eiffel Safety" bike 1800s
11-16-2024 03:05 PM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. Jesper
22 posts
no avatar 2. enkei
19 posts
no avatar 3. GirishH
14 posts
no avatar 4. ReapThaWhirlwind
11 posts
no avatar 5. Flowrider
11 posts