Home Made Heavy Duty Repair

[KC-Steve]

(07-30-2012, 11:29 PM)Bill Wrote:  . . . The idea is really cool but you know what I am looking for is some sort a holder that the bike can be rotated 360 degrees while hooked onto an extruding 1" bar. Yes it could be 3/4" if need be. Just cant figure out what to use?

BTW : I put my trike on this things and the 1/2" wants to bend before the rest of it even moves lol.

Try using a "Tee" but don't tighten it down so you can turn it 360-degrees. That's what I did in the photo below. I also added duct tape to keep from scratching the bike, and used Velcro strap to hold the bike in place while turning. But you probably can't go the entire 360 with that configuration without problems. Hope that helps.

Steve