Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.


Beware Park Tool CCP-44 Incompatible with Shimano Octalink
#1
Purchased this last week and went to pull the crank off today. What I found is that the threaded hollow on the non-drive side is too shallow to fit both the bullet and the threaded extractor nut. With the improvisation, I was still able to remove the non-drive by using a small, thick washer. Certainly not recommended though. I believe I saw Shimano makes their own crank puller for Octalink, so that may have to do with the profile. It was to sell their own tool.

Just want everyone to be aware so you don't find yourself in this same situation.


Attached Files Image(s)
       
  Reply
#2
Thanks for the tip/warning
  Reply


Possibly Related Threads...

Forum Jump:

[-]
10 Latest Posts
🚴‍♂️ Saddle Up for the Belgian Waffle Ri...
Today 08:34 AM
Good Morning from SW Ohio
Today 08:33 AM
Tubeless vs. tubes: What are the pros an...
Today 08:28 AM
The great thing about trikes
Today 08:16 AM
Injury Recovery
Today 08:06 AM
Fellow cyclists, we need your help! Plea...
Today 08:01 AM
New member old rider
Today 07:54 AM
Post-Ride Nutrition
Today 07:52 AM
Pre Ride Food Intake
Today 05:53 AM
First Metric Century
Today 05:29 AM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. Flowrider
19 posts
no avatar 2. GirishH
18 posts
no avatar 3. meamoantonio
12 posts
no avatar 4. Jake1
9 posts
no avatar 5. enkei
9 posts