Rear Wheel Rubbing

wimmers4 · 09-10-2008, 07:35 AM

I am trying to help my 10-yr old change his rear wheel. We purchased a new wheel, installed it and it goes crooked and one side locks against the frame once his weight is put on it. The old wheel was bolt attached and so is the new one. How can we fix this? Thanks.

Alex Ramon · 09-10-2008, 11:14 PM

Are the axle nuts on both sides tight?

wimmers4 · 09-11-2008, 09:09 AM

Yes, actually when we set them into the frame and tighten, the wheel goes against the frame right away, when we set one side up a little from the groove of the frame and tighten, it doesn't happen until he gets on - maybe it's not tight enough. There is a bolt on one side of the new wheel that I was wondering if we could remove, if it is a spacer bolt? Thanks for your reply, Alex.

Alex Ramon · 09-11-2008, 12:22 PM

I wouldn't remove any of the spacers, just make sure the outer bolts are tight enough.

10 Latest Posts
Hatch Chiles Rule! 11-13-2026 06:18 PM
Are you mainly into Mountain Biking, Roa... 11-11-2026 11:08 AM
Are 26" really dying out? 11-11-2026 11:02 AM
Wanted \| Magura Louse or Julie rear 11-11-2026 04:03 AM
Should eBikers have to get an eBike lice... 11-09-2026 05:21 AM
How Bad Are E-bikes By You? 11-08-2026 10:29 PM
Shortness of breath. 11-08-2026 09:56 PM
Hello All 11-06-2026 09:03 AM
I don't usually wear a bike helmet. Does... 11-06-2026 02:48 AM
Chain skips under heavy load when pedall... 11-06-2026 02:44 AM

Join BikeRide on Strava

Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom