04-12-2011, 03:50 PM
1. Using drimel and sandstone I made a slight deep in the center of crank axle.
2. Put bike down on non-drive side.
3. Using rope hang your bike about 2-3 inches high above floor. Hook up rope on crank sprocket as close as possible to axle.
3. hold punch in the center of axle and hit it by hammer.
Disclaimer: for information purpose only, don't do it!!! I will not buy you a new bike and eyes!!!
How bike should be hanged
![[Image: crankremoval001.jpg]](http://i213.photobucket.com/albums/cc87/car6car/crankremoval001.jpg)
deep in the center of axle prevents punch slip.
![[Image: crankremoval002.jpg]](http://i213.photobucket.com/albums/cc87/car6car/crankremoval002.jpg)
I made a punch from a bolt and used vise-grips to hold it.
2. Put bike down on non-drive side.
3. Using rope hang your bike about 2-3 inches high above floor. Hook up rope on crank sprocket as close as possible to axle.
3. hold punch in the center of axle and hit it by hammer.
Disclaimer: for information purpose only, don't do it!!! I will not buy you a new bike and eyes!!!

How bike should be hanged
![[Image: crankremoval001.jpg]](http://i213.photobucket.com/albums/cc87/car6car/crankremoval001.jpg)
deep in the center of axle prevents punch slip.
![[Image: crankremoval002.jpg]](http://i213.photobucket.com/albums/cc87/car6car/crankremoval002.jpg)
I made a punch from a bolt and used vise-grips to hold it.
![[Image: crankremoval003.jpg]](http://i213.photobucket.com/albums/cc87/car6car/crankremoval003.jpg)