Install Chain

Vincent123 · 12-28-2009, 12:35 AM

I just put a chain on a mountain bike. I was on a limited budget so I decided to not use the derailer. So it has only one gear now like a BMX bike. The chain/gears (?) was originally slipping. So I decided to just install a new chain and not use the gears. I have installed the chain. I have a question on the slack needed for the chain. It is very tight. Is that OK?

Alex Ramon · 12-28-2009, 02:07 AM

For single speed setups the chain should be tight, but with a just a tiny bit of slack.

Vincent123 · 12-28-2009, 02:33 AM

(12-28-2009, 02:07 AM)Alex Ramon Wrote: For single speed setups the chain should be tight, but with a just a tiny bit of slack.

The mountain bike is a 21 speed. I first tried to wrap the chain around the fourth cog and it was way too loose so I wrapped it around the fifth cog and it was way to tight (absolutely no slack). What do you suggest?

Alex Ramon · 12-28-2009, 03:39 AM

If that's the case, you'll need a single speed frame, which will have rear-facing dropouts so you can move the axle to adjust the chain tension.

Or you could try using a chain tensioner.

10 Latest Posts
Should eBikers have to get an eBike lice... Yesterday 07:15 PM
How Bad Are E-bikes By You? Yesterday 07:11 PM
Our new review format – we'd like your f... Yesterday 06:59 AM
Which one should I pick? 10-21-2026 08:09 PM
Chain skips under heavy load when pedall... 10-21-2026 07:32 PM
New rider 10-21-2026 07:07 PM
Are 26" really dying out? 10-18-2026 07:38 PM
Using ChatGPT for training 10-18-2026 07:32 PM
2026 Garmin Edge 1050 - warranty 10-18-2026 09:34 AM
Catastrophic bicycle failures 10-16-2026 01:36 AM

Join BikeRide on Strava

Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom