Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.

New: Take Part in the January Giveaway for a Chance to Win the Movcan V80 E-bike Worth $889


Sturmey Archer AW bearing cone spacing
#1
Hi, I have have just restored a very old (circa 1968) raleigh bike. It has an AW 3 speed hub. In my hast to rejuvenate the rear hub I have removed both bearing cones from the rear axle. It appears that the position of the cones on the axle is critical to proper gear operation. How do you reset the correct bearing position? ie If I had the replace the rear axle, how would I reset the correct cone position?

Cheers Aljac
  Reply
#2
Hi Aljac. start here - http://sheldonbrown.com/sturmey-archer.html - and follow the links!
Wheelies don't pop themselves. (from a QBP fortune cookie)
  Reply
#3
Also if you use the keywords "sturmey archer" in the upper right there should be a couple of posts with links on this site. Wink
Good maintenance to your Bike, can make it like the wheels are, true and smooth!
  Reply
#4
(12-18-2010, 04:19 PM)aljac Wrote:  Hi, I have have just restored a very old (circa 1968) raleigh bike. It has an AW 3 speed hub. In my hast to rejuvenate the rear hub I have removed both bearing cones from the rear axle. It appears that the position of the cones on the axle is critical to proper gear operation. How do you reset the correct bearing position? ie If I had the replace the rear axle, how would I reset the correct cone position?

Cheers Aljac

The critical cone is the right hand one (sprocket side). Usually set at the factory and left alone for 50 years or so.
To set it, leave the left hand cone loose or off, then put the lh flatted axle in a vice. Then hand-tighten the rh cone (no wrenches!). Once it has bottomed, back it off half a turn (but no more than 5/8), then drop the lock washer over it and tighten the jam nut, while holding the rh cone steady (15 mm cone spanners). That's it.
Then install lh cone and tighten til there is only a little play in the wheel, lock in place. This is the only one you should mess with as the hub bearings wear with use.
  Reply


Possibly Related Threads...
Thread
Author
Replies
Views
Last Post

Forum Jump:

[-]
10 Latest Posts
The Roaming Radrunner Vlog 1 Why ride ...
Today 11:57 AM
What was your first bicycle?
Today 07:38 AM
How many bikes do you have now?
Yesterday 03:27 PM
Newbie from , Texas
Yesterday 02:41 PM
Operation of Santa Monica Ebike
Yesterday 01:20 PM
Cycling industry is pricing out their ow...
Yesterday 06:40 AM
What are the best maintenance practices ...
Yesterday 06:34 AM
What jockey wheel Red 10 Speed
01-10-2025 02:32 AM
Club Rides
01-09-2025 02:22 PM
Gears and derailleur misalignment
01-09-2025 02:15 PM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. GirishH
24 posts
no avatar 2. enkei
18 posts
no avatar 3. meamoantonio
11 posts
no avatar 4. ReapThaWhirlwind
8 posts
no avatar 5. Painkiller
7 posts