Homemade Headset Press

1FJEF · 10-06-2013, 12:19 AM

Great idea but Polymorph & Instamorph are very expensive. It also might not hold up to abuse.

Joe_W · 10-08-2013, 04:05 AM

Yup, I also guess that the force you need to press in a bearing is likely too high for this plastic stuff. Plus when it starts to give a one side the bearing is no longer centred. If it has been molded to exactly fit the bearing the large surface might redistribute the force well, so this might not be an issue. Keep us posted with the results!

10 Latest Posts
Are you mainly into Mountain Biking, Roa... Yesterday 11:08 AM
Are 26" really dying out? Yesterday 11:02 AM
Wanted \| Magura Louse or Julie rear Yesterday 04:03 AM
Hatch Chiles Rule! 11-09-2026 04:56 PM
Should eBikers have to get an eBike lice... 11-09-2026 05:21 AM
How Bad Are E-bikes By You? 11-08-2026 10:29 PM
Shortness of breath. 11-08-2026 09:56 PM
Hello All 11-06-2026 09:03 AM
I don't usually wear a bike helmet. Does... 11-06-2026 02:48 AM
Chain skips under heavy load when pedall... 11-06-2026 02:44 AM

Join BikeRide on Strava

Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom