Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.

New: Take part in the July Giveaway for an Electric Commuter Bike from KBO Bike


Avenir stems
#1
Anyone have any experience with Avenir stems? They are quite inexpensive, so I want to make sure I'm not buying a piece of junk. I plan to put it on a tandem that I picked up.

-Dave
  Reply
#2
This is what I put on our T50 (120mm stem)
http://www.amazon.com/Avenir-61-27-208-E-200-Series-Stem/dp/B002BW39B2/
http://www.amazon.com/Avenir-Mountain-Handlebars-Black-600mm/dp/B002BW3H4Q/

Works well.

The 200 series is large diameter thin wall aluminum, very stiff and strong; and light wieght.
Nigel
  Reply
#3
Hey Dave. While Avenir is by no means 'fancy' stuff, it is very respectable and I've used many Avenir products over the years.
Avenir is tied to Diamondback like Cycle Design (CD) was to GT years ago or like Bontrager is to Trek today.
Wheelies don't pop themselves. (from a QBP fortune cookie)
  Reply
#4
Excellent. I have the stem and I'm going to put it on the bike tomorrow if I'm lucky, or saturday if I'm unlucky.

Thanks for the replies!
  Reply
#5
Were you lucky or unlucky?
Wheelies don't pop themselves. (from a QBP fortune cookie)
  Reply
#6
I think it finally went on that sunday. It seems to be fine, though. It's a 1.25" stem and my bar is only 1", and the shims it came with were a little difficult to work with, but I got it together. Now I just need to replace the seat post with one with 0 setback and then I'll be good to go!
  Reply
#7
1 1/4 or 1 1/8 ?

Be safe; get a different stem that matches your bars, or get bars that match your stem; shims are not great to work with on such as safety critical area as the handle bars.
Nigel
  Reply
#8
1-1/4. They were difficult in the sense that they kept falling out when I was tightening the face plate nuts rather than them not fitting flush
  Reply


Possibly Related Threads...
Thread
Author
Replies
Views
Last Post

Forum Jump:

[-]
10 Latest Posts
Campagnolo Atlanta Quandary
Today 10:46 AM
Tools required for SunTour Cassette remo...
Today 08:12 AM
Does the B limit screw cause grinding in...
Yesterday 09:37 PM
Bike Brake Calipers Not Springing Back
Yesterday 07:08 PM
Chip in carbon frame. Do I need to get p...
Yesterday 09:05 AM
What are your best biking places in your...
Yesterday 08:04 AM
What to do about scratched carbon fork?
Yesterday 01:07 AM
Water in tube.
07-27-2021 11:50 AM
New bike advice
07-27-2021 07:18 AM
Spacing of the rear part of the steel fr...
07-27-2021 02:25 AM

[-]
Top 5 Posters This Month
no avatar 1. Jesper
34 posts
no avatar 2. ReapThaWhirlwind
15 posts
no avatar 3. JR Namida
9 posts
no avatar 4. Criminal
7 posts
no avatar 5. Dalton Bourne
5 posts