Hi,
I just lost my second spoke in as many weeks on my 700c roady rear wheel. Is this a sign that my wheel, which has done about 1000miles, is due for replacement?
Can I just keep replacing spokes and how can I tell if the whole wheel is shot?
1000 miles is not a lot for a road wheel.
Obviously depends on how you treat them.
To me a wheel is good until it's physically damaged (dented rim) or the rim is worn through due to braking.
Replace the spokes and have the wheel re-trued and tensioned.
If you can do the truing yourself then fine but don't forget to stress relieve the spokes.
See Sheldon:- Scroll down the page.
http://www.sheldonbrown.com/wheelbuild.html
Also see:-
http://bikeride.com/broken-spoke/
Ride hard or ride home alone!
If there's no physical damage to the spokes, it's probably a sign that the wheel isn't properly tensioned (or is underbuilt for how you ride). Having the wheel properly tensioned may help. Getting it respoked comes down to cost. It might be cheaper to get a new wheel than replace the old one. But either way. Have someone hand check the spoke tension either way though.
Where did the spoke break? Did the head break off of the nipple at the rim? Did the spoke break at the J-bend at the hub? As Dave asked - any damage to the spokes from the chain getting between the spokes and the cassette and chewing them up?
Wheelies don't pop themselves. (from a QBP fortune cookie)
I am a BIG guy; and have broken spokes in several wheels. Due to economic considerations, I built an inexpensive truing stand, and learned how to replace spokes and rebuild wheels.
After a bit of research, especially on Peter White's website, I use Wheelsmith spokes exclusively, high tension and stress relieve - result, no more broken spokes. All my wheels are 36 spokes, except one rear wheel which is 40 spokes.
Nigel
Thanks for all the advice guys,
The spoke snapped very clean just after the J-bend at the hub.... No interference from chain as far as i know, i don't think the chain has ever come off actually.
Think i might try the whole home made truing stand thing, the retail ones are tre expensive!! Especially when a spoke is just a couple of pounds at most...
Thanks all
nfmisso. How you get so smart?!
Wheelies don't pop themselves. (from a QBP fortune cookie)