Have questions or want to discuss cycling? Join Now or Sign In to participate in the BikeRide community.

Best Black Friday E-Bike Deals 2024 | Up to $1,700 in Savings

New: Take Part in the November Giveaway: Starts November 18th


"Droopy" chain problem...
#1
Hi - another newbie to this forum with an annoying road bike problem... My Trek Madone 5.2 Triple has a Shimano Ultegra rear derailleur.
With the largest front and smallest rear sprocket combo engaged, when free-wheeling the chain flops onto the frame lower bracket - is this normal?
I have tried adjusting the B tension screw and I have even removed a chain link to increase the tension without success. All the gears engage properly and the chain slack problem only applies to the above combo.
Any suggestions would be much appreciated.<br />
Kevin

  Reply
#2
You say this happens when you "freewheel". Just to confirm, I think you mean that it only happens when you are rolling, but not pedaling (coasting). If so, it sounds like your freehub is not spinning freely. It is getting dragged forward by the wheel slightly which takes the tension off the chain. This could result from wearing freehub or a bent axle which is rubbing on the inside of the freehub body. I'd take off the wheel and cassette and check it out a little.
BTW, you may have made your chain too short now. Not a big issue, but be careful going into the big-big combination, you could tweak your rear derailleur.

  Reply
#3
Hi,

I am also having the same problem when I am pedaling backwards. I have replaced my freehub to accommodate a new 9 gear cassette. The freehub spins correctly until I tighten down the axle to eliminate any free play and provide a freely rotating rear wheel. I have found that a rubber dust/water seal that sits on the freehub side of the axle is the culprit. At the moment the “cup side” of this rubber seal is facing the bearing retainer of the freehub. If I use the tapered side, the other side of the seal, it will get squashed when I tighten up the axle. Either way, this seal is causing enough friction to interfere with the freehub’s rotation thus the saggy chain.

Is this normal and I should just let both parts wear in?
Have I used the correct side to seal the bearing retainer?
Is the seal the correct size for this freehub it worked fine with the older and shorter freehub?

Thx,
  Reply
#4
Assuming that it's all assembled correctly, it could be just a bit tight as it's new, it's difficult to tell without actually having a look. Also make sure it's well lubricated and the seal is not "dry".

It may also be that your chain is a bit too long. Shift the chain onto the largest sprocket at the rear and the largest chainwheel at the front. Is there still a lot of slack in the chain? If so, pinch the chain together to calculate how many links you could remove without having the rear deraileur cage pulled too far forwards and under too much tension.

If you want to calculate chain length more accurately, take a look here: http://bikeride.com/calculate-chain-length/
  Reply
#5
^He's right, could easily be that.

I got a new bike a few years ago from a very good bike shop, but the chain was really a bit long. I use Alex's chain length calculator and took nearly 3 complete links out of it. Rock gardens were not much of an issue for the chain anymore (certainly not now I have a chain device Smile )
  Reply
#6
Hey thanks for the replay guys,

I am pretty sure the problem is with the dust seal and the freehub bearing retainer. The freehub rotates freely until the axle is tightened down to remove any wheel wobbles while maintaining smooth rotations. There must be a slight size different between the old and new bearing retainer in the freehub. Does this axle seal come in different sizes?

I have not seen anything on the net that even addresses this axle seal.

Thx
  Reply


Possibly Related Threads...
Thread
Author
Replies
Views
Last Post
 
7,729
01-17-2015, 02:02 PM
Last Post: nfmisso
 
7,084
07-05-2014, 09:50 AM
Last Post: cny-man
 
12,852
09-17-2010, 12:48 AM
Last Post: Luna
 
11,659
03-07-2009, 09:11 AM
Last Post: cyclerUK

Forum Jump:

[-]
10 Latest Posts
Second wheelset for ebike.
Today 01:41 AM
Moving in Style: Beyond Regular Transpor...
Yesterday 09:23 PM
Tire Sizing (Or How to Buy A Tire)
Yesterday 12:36 PM
The Roaming Radrunner Vlog 1 Why ride ...
Yesterday 09:17 AM
Recording Bike Rides
11-20-2024 01:37 AM
Ketone Ester $$$
11-19-2024 01:04 AM
Trek domane tyre
11-18-2024 01:58 PM
Old fossil buys Ebike
11-17-2024 06:39 AM
Bike bus
11-17-2024 12:14 AM
Humber "Eiffel Safety" bike 1800s
11-16-2024 03:05 PM

[-]
Join BikeRide on Strava
Feel free to join if you are on Strava: www.strava.com/clubs/bikeridecom

[-]
Top 5 Posters This Month
no avatar 1. Jesper
22 posts
no avatar 2. enkei
19 posts
no avatar 3. GirishH
14 posts
no avatar 4. ReapThaWhirlwind
11 posts
no avatar 5. Flowrider
11 posts